Tradescantia: Potted Perennial Plant
How to Plant
Planting in the Garden:
- Choose a location in full sun or part shade, with moist, well-drained soil. Plants tolerate wet locations.
- Prepare the bed by turning the soil under to a depth of 6-12 inches removing any debris, and lightly raking as level as possible.
- The addition of organic matter (leaf mold, compost, well-rotted manure) benefits all gardens and is essential in recently constructed neighborhoods.
- Plant on a cloudy day or in late afternoon to reduce transplant shock.
- Dig a hole for each plant large enough to amply accommodate the root ball.
- Unpot the plant and gently loosen the root ball with your hands to encourage good root growth.
- Place the top of the root ball even with the level of the surrounding soil. Fill with soil to the top of the root ball. Press soil down firmly with your hand.
- Use the plant tag as a location marker.
- Thoroughly water and apply a light mulch layer on top of the soil (1-2 inches) to conserve water and reduce weeds.
How to Grow
- Keep weeds under control during the growing season. Weeds compete with plants for water, space and nutrients, so control them by either cultivating often or use a mulch to prevent their germination.
- Mulches also help retain soil moisture and maintain even soil temperatures. For perennials, an organic mulch of aged bark or shredded leaves lends a natural look to the bed and will improve the soil as it breaks down in time. Always keep mulches off a plant’s stems to prevent possible rot.
- Careful watering is essential in getting perennials off to a good start. Water thoroughly at least once a week to help new roots grow down deeply. Soil should be damp at about 1 inch below the soil surface. You can check this by sticking your finger in the soil. Water early in the morning to give all leaves enough time to dry. One inch of rain or watering per week is recommended for most perennial plants. You can check to see if you need to add water by using a rain gauge.
- Until plants become established, some protection from extreme winds and direct, hot sunlight may be necessary. Good air movement is also important.
- After new growth appears, a light fertilizer may be applied. Keep granular fertilizers away from the plant crown and foliage to avoid burn injury. Use low rates of a slow release fertilizer such as Garden-tone, as higher rates may encourage root rots.
- “Deadhead”, remove spent flower heads to encourage continuous flowering and prevent seed development.
- Remove and discard foliage after a hard frost in fall.
- In colder regions, apply another layer of mulch (1-2 inches) after the ground freezes in fall. Evergreen boughs (from Christmas trees) provide additional protection. Remove this mulch in the spring.
- Many gardeners do not cut back perennial flower seed heads in the fall, but wait until early spring before the new foliage appears. This provides food for wildlife over the winter.
- After the plants flower, cut them down to about 6 inches for more compact foliage and to encourage new blooms.
- Divide plants every 3 to 4 years in spring to prevent overcrowding and to keep them spreading too quickly.
Common Disease Problems
Botrytis: This fungus causes a grey mold on flowers, leaves, stems and buds. It thrives in cool wet weather conditions. Burpee Recommends: Remove affected plant parts, avoid watering at night and getting water on the plant when watering. Make sure plants have good air circulation. Contact your Cooperative Extension Service for fungicide recommendations.
Root Rots: A number of pathogens cause root rots. Burpee Recommends: Pull up and discard infected plants. Make sure your soil has excellent drainage. Contact your Cooperative Extension Service for recommendations.
Rust: A number of fungus diseases that cause rust colored spots on foliage and stems. Burpee Recommends: Remove infected plant parts. Contact your Cooperative Extension Service for recommendations.
Septoria Leaf Spot: This disease is most severe during rainy seasons in closely planted gardens. Circular spots with gray centers and dark margins appear on the lower older leaves. Fungal spores are produced and darken the center of the spots. Burpee Recommends: Remove and destroy infected plant debris. Don't handle or brush against plants when they are wet. Remove weeds growing nearby.
Virus (Various causes): The most characteristic sign of virus is tight and dark green mottling of the leaves. Young leaves may be bunched. Young plants may have a yellowish tone and become stunted. Fruit is usually not affected in outward appearance, but it may be smaller and scarcer. Leaflets may point upward and have a grayish cast. Burpee Recommends: Destroy diseased plants and the plants on either side.
Common Pest and Cultural Problems
Aphids: Greenish, red, black or peach colored sucking insects that can spread disease as they feed on the undersides of leaves. They leave a sticky residue on foliage that attracts ants. Burpee Recommends: Introduce or attract natural predators into your garden such as lady beetles and wasps who feed on aphids. You can also wash them off with a strong spray, or use an insecticidal soap.
Mealybugs: Mealybugs are 1/8 to ¼ inch long flat wingless insects that secrete a white powder that forms a waxy shell that protects them. They form cottony looking masses on stems, branches and leaves. They suck the juices from leaves and stems and cause weak growth. They also attract ants with the honeydew they excrete, and the honeydew can grow a black sooty mold on it as well. Burpee Recommends: Wash infected plant parts under the faucet and try to rub the bugs off. They may also be controlled by predator insects such as lacewings, ladybugs and parasitic wasps. Check with your Cooperative Extension Service for pesticide recommendations.
Slugs: These pests leave large holes in the foliage or eat leaves entirely. They leave a slime trail, feed at night and are mostly a problem in damp weather. Burpee Recommends: Hand pick, at night if possible. You can try attracting the slugs to traps either using cornmeal or beer. For a beer trap, dig a hole in the ground and place a large cup or bowl into the hole; use something that has steep sides so that the slugs can’t crawl back out when they’re finished. Fill the bowl about ¾ of the way full with beer, and let it sit overnight. In the morning, the bowl should be full of drowned slugs that can be dumped out for the birds to eat. For a cornmeal trap, put a tablespoon or two of cornmeal in a jar and put it on its side near the plants. Slugs are attracted to the scent but they cannot digest it and it will kill them. You can also try placing a barrier around your plants of diatomaceous earth or even coffee grounds. They cannot crawl over these.
Spider Mites: These tiny spider-like pests are about the size of a grain of pepper. They may be red, black, brown or yellow. They suck on the plant juices removing chlorophyll and injecting toxins which cause white dots on the foliage. There is often webbing visible on the plant. They cause the foliage to turn yellow and become dry and stippled. They multiply quickly and thrive in dry conditions. Burpee Recommends: Spider mites may be controlled with a forceful spray every other day. Try hot pepper wax or insecticidal soap. Check with your Cooperative Extension Service for miticide recommendations.
Thrips: Thrips are tiny needle-thin insects that are black or straw colored. They suck the juices of plants and attack flower petals, leaves and stems. The plant will have a stippling, discolored flecking or silvering of the leaf surface. Thrips can spread many diseases from plant to plant. Burpee Recommends: Many thrips may be repelled by sheets of aluminum foil spread between rows of plants. Remove weeds from the bed and remove debris from the bed after frost. Check with your Cooperative Extension Service for pest controls.
Can I grow tradescantia in a container? Yes, tradescantia is fine for containers.
Is tradescantia deer resistant? No, tradescantia is not deer resistant.
Is tradescantia a good pollinator plant? Yes, it attracts bees.
Should I deadhead my tradescantia? Yes, this can help prolong blooming.
Does tradescantia seed itself? A single plant is self-sterile, but if there is another tradescantia nearby they will produce seed and self sow.